Preference-audio P-1200 Manuel d'utilisateur Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
10
O W N E R ’ S M A N U A L
P-1200
S P E C I F I C A T I O N S
(continued)
S E T U P (continued)
Frequency Response: 28Hz – 300Hz (System Response)
Crossover Frequency: 40Hz – 120Hz (Low-pass lter with bypass switch)
Phase Adjustment: 0 – 180 degrees (Continuously variable)
Amplier Output Power: 300 watts, with thermal and clipping limiters
Audio Inputs: Summing stereo line level (RCA x2)
LFE (RCA shared with Left input connector)
Speaker level (Stereo 5-way binding post)
Input Impedance: Line Level – 20kohms, Unbalanced
Speaker Level – 220 ohms
Input Power: 120V 60Hz AC
Input Power Connection: IEC 2-wire receptacle with integral fuse holder
Power (Mains) Fuse: 3A 250V GMA style Fast Blow
Power Modes: Auto signal sensing and always on
Auto Off Delay: ~10 minutes
Dimensions: 15-3/8"W x 17-5/16"H x 14-3/4"D, (390W x 440H x 375D)mm (without feet)
Weight: 43lbs (19.5kg)
Shipping Dimensions: 21"W x 20"H x 20"D, (533W x 508H x 508D)mm
Shipping Weight: 51lbs (23.2kg)
Fine Tuning the Controls
Crossover Switch
If you choose to bypass the internal crossover and use an external crossover, such as those located in most
modern receivers and processors, then you will need to ne tune the system based on the adjustments
provided by the manufacture of your electronics in conjunction with the Level and Phase controls on the
P-1200. Note, the Level and Phase adjustments on the P-1200 are not bypassed and will still function as
indicated above.
To bypass the internal crossover, move the Crossover switch to the Bypass position. The subwoofer will
now pass signals up to approximately 300Hz.
Auto Power Mode Switch
The P-1200 contains a circuit that automatically powers up the amplier when a signal is detected. The
same circuit also places the P-1200 into standby mode when no signal has been detected for a period of
approximately 10 minutes. This signal sensing circuit can be bypassed by switching the Auto switch to
the OFF position if it is preferable to control the P-1200’s power with a remotely operated power source.
6
2
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire